Danair AH-15-GL Glazing Tool
The Daniar model AH-15-GL pneumatic Glazing Tool is designed for installing urethane glazing. It can be used with specialty tips for a wide range of specific applications. This tool is very adaptable. Contact Danair, Inc. today to see if this tool may help modify your existing AH-15 Automatic Hammer to better suit your application.
Features & Benefits
- Performance - the Danair, Inc. AH-15 Auto-Hammer® has no trigger. Hammering action begins with a light pressure on the working surface and stops when lifted away. The AH-15 Auto-Hammer® will deliver over 1000 BLOWS PER MINUTE!
- Quality - Since 1967 Danair, Inc. Products have been made in the U. S. with only the finest materials. Anytime during the LIFETIME of the tool a failure occurs because of workmanship or defective materials Danair, Inc. will repair or replace that tool.
- Availability - AH-15 Auto Hammers® and parts are IN STOCK at many Danair, Inc. Dealer Locations around the world and the factory in Elko, Nevada. Orders received in the morning at the factory are often shipped the same day.
Specifications
- Operating pressure: 50-125 PSI
- Air Consumption: 2-4 CFM
Maintenance
*NOTE: ALWAYS USE A 6 TO 10 WEIGHT NON-DETERGENT OIL FOR LUBRICATION. WHEN CLEANING INTERNAL PARTS, AVOID USE OF SOLVENTS ON ALL RUBBER & URETHANE PARTS. USE OF DETERGENT OILS AND SOLVENTS WILL DAMAGE THE INTERNAL RUBBER AND URETHANE PARTS. **LACK OF LUBRICATION WILL CAUSE THE TOOL TO RUN SLOW AND HANG UP. IT CAN ALSO CAUSE PREMATURE WEAR ON INTERNAL PARTS. ***ANY DEBRIS IN THE TOOL, WHETHER FROM DAMAGED URETHANE PARTS OR FROM AN UNFILTERED AIR SUPPLY, WILL CAUSE THE TOOL TO FAIL.